FC Specifications

MCU: STM32F405RGT6, 168MHz , 1MB Flash

IMU: ICM42688-P

Baro: DPS310

OSD: AT7456E

Blackbox: MicroSD card slot

6x UARTs,  1x Softserial_Tx option(INAV)

10x PWM outputs

2x I2C

3x ADC (VBAT, Current, RSSI)

Built in inverter for SBUS input

USB Type-C(USB2.0)

FC Firmware

ArduPilot: MatekF405-Wing (ArduPlane 4.4 or newer)

INAV: MATEKF405SE (INAV 6.0 or newer)

PDB

Input voltage range: 9~30V (3~6S LiPo) w/TVS protection

Current Senor: 220A,  3.3V ADC  (INAV scale 150,  ArduPilot 66.7A/V)

Sense resistor: 100A continuous, 220A peak

Battery Voltage divider 1K:10K (Scale 1100 in INAV,  BATT_VOLT_MULT 11.0 in ArduPilot)

BEC 5V output

Designed for Flight controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeed

Continuous current: 2 Amps

BEC 9V /12V output

Designed for Video Transmitter, Camera, Gimbal ect.

Continuous current: 2 Amps

12V option with Jumper pad

for stable 9V/12V output, input voltage should > output voltage +1V

BEC Vx output

Designed for Servos

Voltage adjustable, 5V Default, 6V or 7.2V options

Continuous current: 5 Amps,  6A Peak

for stable Vx output, input voltage should > Vx voltage +1V

BEC 3.3V output

Designed for external 3.3V peripherals

Linear Regulator

Continuous current: 200mA

Physical

Mounting: 30.5 x 30.5mm, Φ4mm with Grommets Φ3mm

Dimensions: 54 x 36 x 13 mm

Weight: 25g

Including

1x F405-Wing-V2

1x 20cm JST-GH-4P to JST-GH-4P cable for I2C port

Dupont 2.54 pins  (Board is shipped unsoldered)